Xycd60 Manual → | TRUSTED |

Long press the DOWN button to toggle the backlight sleep mode. "On" keeps the light on; "OFF" turns the light off after 5–10 minutes of inactivity. Safety Precautions

In this mode, the module connects the charger to the battery when the voltage drops below a set lower limit () and disconnects it when the battery reaches the upper limit ( UP ). Condition to Start: Voltage ≤is less than or equal to dn . Condition to Stop: Voltage ≥is greater than or equal to UP . 2. Discharging Mode (dn) xycd60 manual

If OP is set, the relay will automatically disconnect after the specified duration, even if the voltage threshold hasn't been reached. This acts as a safety backup. Long press the DOWN button to toggle the

Percentage=Current Voltage−dnUP−dn×100%Percentage equals the fraction with numerator Current Voltage minus dn and denominator UP minus dn end-fraction cross 100 % Condition to Start: Voltage ≤is less than or equal to dn

This mode is used to protect batteries from deep discharge. The module connects the load when the battery is full and disconnects it once the voltage hits a minimum threshold. Voltage ≥is greater than or equal to UP . Condition to Stop: Voltage ≤is less than or equal to dn . Setting Up the XY-CD60 Entering Setup