Sinotimer | Mc101 Manual [upd]

If using an SSR to control a high-current load, always attach a heat sink to prevent the relay from overheating.

For models, use the internal relay contacts to switch your load.

Sinotimer devices are built to resist dust and moisture, but they should still be housed in a proper enclosure for longevity in harsh environments. Temperature Controller - Sinotimer sinotimer mc101 manual

Supports multiple thermocouple types (K, J, E, N) and thermal resistance (RTD) inputs.

Hold the (or SET + <) keys for 3 seconds to enter the menu. Use the arrows to find the "Unit" parameter. Change the value from 000 (Celsius) to 001 (Fahrenheit). Hold the MODE key for 3 seconds to exit and save. Entering PID Auto-Tuning: If using an SSR to control a high-current

0.3% measurement accuracy with a maximum resolution of 0.1°C for thermocouples and RTDs.

Set "AT" to 1. The AT light on the panel will blink until the cycle is complete and the controller has calculated its PID constants. The AT light on the panel will blink

Connect the positive and negative leads to the designated input terminals (check label for polarity).

Connect the resistor element between Terminals 8 and 9 , with the third "extra" wire going to Terminal 10 . Control Output:

Four-digit dual LED display showing both the PV (Process Value) and SV (Set Value). Dimensions: Standard 48x48mm (1/16 DIN) panel mounting. Power Supply: Operates on AC 100-240V at 50/60Hz. Wiring and Installation Guide