Simrad Rf300 Installation Manual -

Before securing the unit, rotate the transmitter lever until the alignment marks are perfectly centered. These marks should be opposite the cable entry point of the feedback unit. Tiller Arm Connection:

Once physically installed, you must configure the autopilot software to recognize the unit. Installation manual simrad rf300 installation manual

Connect the transmitter rod to the ball joint on the tiller arm. Before securing the unit, rotate the transmitter lever

Install the RF300 on a stable platform near the rudder post. The center of the RF300 should ideally be in line with the center of the rudder post to ensure geometric accuracy. Before securing the unit