Rdu-a G2 User Manual -

Physical MountingThe RDU-A G2 is designed for panel mounting.Cut a hole in your panel according to the dimensions specified in the technical drawing (typically 92x45mm).Slide the unit through the cutout from the front.Secure the unit using the side-mounting clips provided.

Setting the Input TypeThe G2 model supports various input signals (4-20mA, 0-10V, etc.). You must select the input type that matches your sensor to ensure correct scaling and readouts. Operating Modes

Accessing the MenuPress and hold the 'SET' button for three seconds to enter the configuration menu. Use the arrow keys to navigate through the parameters. rdu-a g2 user manual

Always disconnect power before servicing.Do not exceed the rated voltage limits.Installation should be performed by a qualified technician familiar with electrical standards. Conclusion

RDU-A G2 User Manual: The Complete Guide to Setup and Maintenance Physical MountingThe RDU-A G2 is designed for panel mounting

Unboxing and InspectionBefore starting, ensure you have the RDU-A G2 unit, mounting brackets, and the terminal connector block. Check for any visible damage during shipping.

Common Troubleshooting Tips:Display is Blank: Check power supply voltage and polarity.Erroneous Readings: Verify that the input scaling matches the sensor’s output range.No Communication: Check the baud rate and parity settings in the communication menu. Safety Precautions Operating Modes Accessing the MenuPress and hold the

By following this user manual, you can maximize the reliability and accuracy of your RDU-A G2. For advanced integration or specific firmware updates, always refer to the latest manufacturer documentation.

Power Input: 12-24V DCDisplay: High-resolution backlit LCDOperating Temperature: -10°C to 60°CConnectivity: RS485, Modbus RTU, and optional Wireless modulesEnclosure Rating: IP65 (Front panel) Initial Setup and Installation