Icom Ci V Usb Interface Schematic Top «2026 Edition»

Building your own Icom CI-V (Communications Interface 5) USB interface is a popular DIY project for amateur radio operators. It allows you to control transceivers—from older models like the IC-735 to modern rigs—via a computer using a single 3.5mm mono cable. Understanding the CI-V Bus

Multiple Icom devices can be connected in parallel; each is identified by a unique hex address. Core Schematic: USB-to-TTL (CI-V) icom ci v usb interface schematic top

The simplest way to interface a standard USB-to-TTL module (which has separate TX and RX pins) with the single-wire CI-V bus is to bridge the signals. Building your own Icom CI-V (Communications Interface 5)

To build a modern USB version, you need a (often based on the FTDI FT232RL or CP2102 chips). The "Two-Diode" or "Shorted" Method Core Schematic: USB-to-TTL (CI-V) The simplest way to

For a more robust "top-tier" design that prevents data collisions and protects your radio, use an like the 7417 or 7407 . Simple Icom CI-V Interface - QSL.net

Connect the TXD pin of your USB module to the Tip of a 3.5mm mono jack through a small signal diode (e.g., 1N4148) with the cathode facing the USB module. This prevents the TX pin from holding the bus high when it should be idle. RX to DATA: Connect the RXD pin directly to the same Tip . Ground: Connect the GND pin to the Sleeve of the mono jack. Buffered Open-Collector Schematic