Accessory 2 or Second Ignition. Check your vehicle's specific requirements to see if this is needed for the HVAC system.
Starter output. Connects to the vehicle’s starter wire; this is the wire that only shows 12V when the key is in the "start" position.
Which (e.g., trunk pop, window roll-up) you are having trouble wiring. Challenger Ch 1000 Owner Installation Manual
Constant 12V power. Connect to a high-current 12V source, typically found at the ignition switch or battery.
Check the transmitter range in an open area to ensure the antenna is placed optimally (usually high on the windshield). ⚠️ Important Safety Warning Accessory 2 or Second Ignition
Wait for the LED to flash or the siren to chirp, indicating the tach signal has been stored. Feature Selection
Brake Switch Input. This is a critical safety feature that shuts down the engine if the brake is pressed without the key in the ignition. Connects to the vehicle’s starter wire; this is
The system needs to know when the engine has successfully started so it can stop cranking the starter. Start the engine manually with the key. Press and hold the .