Cem Dual Mig — 120 Manual

If the machine gets too hot, the thermal cut-out will trip. The light will turn on, and the welder will stop until it cools down. 3. Setup and Wire Loading

Flip the tensioner arm, thread the wire through the guide liner, over the roller, and into the torch lead. cem dual mig 120 manual

As the name suggests, it is "Dual" because it can often be configured for Gas (MIG) or Gasless (Flux-Cored) welding by reversing the polarity. 2. Control Panel Breakdown If the machine gets too hot, the thermal cut-out will trip

This usually means your shielding gas is off, empty, or there’s a breeze blowing the gas away. If using gasless wire, it means the metal is too dirty. Setup and Wire Loading Flip the tensioner arm,

These are consumables. If the wire is "stuttering," replace the copper tip at the end of the torch.

If the wire won't feed even with high tension, your torch liner might be kinked or clogged with dust. 5. Troubleshooting Common Issues

If you are looking at the face of the machine without a manual, here is what the controls generally do: These are your voltage settings. Min + 1: Lowest power (thin sheet metal). Max + 2: Highest power (thicker steel up to 3-4mm).